|
Written by Techbricks.nl
|
|
Tuesday, 26 February 2008 09:38 |
I was enble to make my onw NXT cables (part no: 55804) using a crimping tool. The velleman crimping tool (HT 2000D) is a tong which is meant to crimp 4, 6 or 8 pin connectors to flat cables like pin RJ11, RJ12, RJ45 cable plug connectors. NXT connector
plug is a 6 pin connector that is very much like a RJ12 connector. The latch is moved to the right of the connector and is smaller then RJ12 latch.
After removing the screw the crimping tool is able to connect NXT connectors/plugs to flat cable.
The nxt cable connector in the crimping tool pressed together:
The back site of the crimping tool:
The flat cable (6 wires in a cable) and the connectors/plugs:
I ordered the plugs at Mindsensors (plug-nx).
The result:
Check Philippe E. Hurbain site about NXT cable plugs...
Check the complete NXT cable connector plug crimping tool high resolution photo gallery at Google Picasa...
|
Copyright © 2010 www.techbricks.nl. All Rights Reserved. Please, email to
techbricks.nl@gmail.com if you have any questions about this site.
This site is not associated with the LEGO(c) Group or the LEGO(c) Corporation in any way. This is an independent site generated by a fan of LEGO(c) products. LEGO(c) is a trademark of the LEGO(c) Group which does not sponsor, authorize or endorse this site.
NXT cable crimping tool
